Shogun Motorsports Yamaha FZ6R (09-10) NO CUT Frame Slider - Manual

Yamaha FZ6R (09-10) No Cut Frame Slider
Installation Instructions
Part Numbers: 750-6369, 750-6360
MADE IN THE USA!
Carefully read instructions in their entirety before the install
Professional installation is recommended. Always use proper safety measures during the install of this
product. Do not try to install this product without proper tools, recently calibrated torque wrench,
correct torque specifications from
factory service manual , safety goggles and gloves. The motorcycle
must be in a fixed secure position before the install process begins. DO NOT remove both engine studs
at the same time.
Shogun is not responsible for any part of your motorcycle for any reason. Precisely
measure location of cut and if in doubt at any point please call us before the install process has begun.
Replacement Parts List: Left Side Components (as if you were sitting on the bike)
QTY
Price each Part Numbers Descriptions
1
$20.00 99-FS-750-6369-L Black Left Side Puck
1 $20.00 99-FS-750-6360-L White Left Side Puck
1 $20.00 99-OF-750-6360-L Left Side Offset Black Anodized
1 $2.00 99-HB-SH10150045 Socket Cap 10 X 1.5 X 45 (Holds puck to offset)
1 $3.50 99-HB-SH10125060 Socket Cap 10 X 1.25 X 60 Main Engine Stud
Replacement Parts List: Right Side Components (as if you were sitting on the bike)
1
$20.00 99-FS-750-6369-R Black Right Side Puck
1 $20.00 99-FS-750-6360-R White Right Side Puck
1 $20.00 99-OF-750-6360-R Right Side Offset Black Anodized
1 $2.00 99-HB-SH10150045 Socket Cap 10 X 1.5 X 45 (Holds puck to offset)
1 $3.50 99-HB-SH10125045 Socket Cap 10 X 1.25 X 45 Main Engine Stud
Frame Sliders: Left frame slider longer than right
Offsets: Both offsets have a flat side (side that the frame slider mounts to). Lay both on a table the one
that is taller (or thicker) is the left side.
NOTE: This kit has TWO 10 X 1.5 X 45 (Coarse Threaded Socket Cap Bolts) and ONE 10 X 1.25 X 45 (Fine
Threaded Socket Cap Bolt). THE FINE THREADED BOLT IS THE MAIN ENGINE STUD BOLT FOR THE RIGHT
SIDE.
DO NOT TRY TO THREAD IN 10 X 1.5 X 45 COARSE THREADED BOLT INTO ENGINE CASE OR IT WILL CAUSE
DAMAGE!!!
Installation Steps:
1.
Remove left and right body panels.