Shogun Motorsports Suzuki GSXR1000 (05-11) Axle Slider - Manual

General Axle Slider Installation Instructions
Part Numbers: 702 Series
MADE IN THE USA!
Carefully read instructions in their entirety before the install
Professional installation is recommended. Always use proper safety measures during product installation. Do not
try to install this product without proper tools, recently calibrated torque wrench, correct torque specifications
from
factory service manual , safety goggles and gloves. The motorcycle must be in secured in a fixed position
before the install process begins. Shogun is not responsible for any damage caused to your motorcycle. If you are
performing your own installation (not suggested) and are unsure about the following directions any point please
call us before the install process has begun.
NOTE:
These instructions are GENERAL use only! Some motorcycles vary from brand or model; refer to your OEM
service manual for all torque specs, disassembly and assembly instructions.
Replacement Parts List: Left Side Components (as if you were sitting on the bike)
QTY
Price each Part Numbers Descriptions
1
$15.00 99-AS-702-0100 Black Left Side Puck
1 $15.00 99-AS-702-0200 Black Left Side Puck (KAWASAKI ONLY)
1 $18.99 99-HN-SS141525 Stainless Steel Machined Axle Bolt
1 $0.49 99-HN-LN8125 8mm Lock nut
1 $0.10 99-HWMO8WASH 8mm Washer
Replacement Parts List: Right Side Components (as if you were sitting on the bike)
1
$15.00 99-AS-702-0100 Black Right Side Puck
1 $15.00 99-AS-702-0200 Black Right Side Puck (KAWASAKI ONLY)
1 $5.00 428-9086 Machined Spacer (HONDA/YAMAHA ONLY)
1 $5.00 428-9087 Machined Spacer (SUZUKI ONLY)
1 $0.49 99-HN-LN8125 8mm Lock nut
1 $0.10 99-HWMO8WASH 8mm Washer
1 $15.99 99-HR-TH8125485 Stainless Steel Machined Axle Rod
1.
Remove left side OEM axle bolt. (If Required)
2.
Install Shogun stainless steel machined axle bolt (99-HN-SS141525) and torque down. Refer to
your service manual for proper torque specs. (If Required)
3.
Using stainless steel machined axle rod (99-HR-TH8125485) 8mm lock nut (99-HN-LN8125) 8mm
washer (99-HWMO8WASH) slide rod through axle puck (99-AS-702-0100) and slide assembly
through front axle shown in pictures below.