Shogun Motorsports Honda CBR600RR (13-14) NO CUT Frame Slider - Manual (Page 6)

6.
Line up the edge of the offset (wile mounted) with the edge of the frame and torque down to
OEM torque specs using the stock OEM 12mm Hex Flange bolt. Make sure that the coolant line
is secure, routed properly and is not being pinched by the offset or clutch cable in anyway.
7.
Remount lowers left and right
8.
On the left side use one drop of blue thread locker on the (99-HB-SH10125080) Socket Cap 10 X
1.25 X 80 (Holds puck to offset). Torque down to 30 to 32 foot lbs. On the right side use one
drop of blue thread locker on the (99-HB-SH10125070) Socket Cap 10 X 1.25 X 70 (Holds puck to
offset). Torque down to 30 to 32 foot lbs.