Shogun Motorsports YamahaYZFR6 (08-13) Frame Slider - Manual (Page 3)

7.
Remove the bodywork and double check location of spot mark the tool has created.
8.
Using a small drill ¼ inch or so drill a pilot hole in the body from the inside out. Remount
bodywork and double check the hole location with the spot tool still inserted.
9.
An easy way to have an accurate template is to create a 2.25 x 2.25 square of masking tape. Lay
it out on the table. Turn the slider upside down and center it on the masking tape. Using a
pencil trace around the slider. Mark your center point and line it up with the hole you drilled in
the bodywork.
10.
For this application we used a dremel tool with a sanding roll to open up the hole little by little.
MAKE SURE YOU WEAR PROTECTIVE GOGGLES AND GLOVES As you cut and open the hole to
your scribe marks keep checking that the hole is lining up with your puck dimensions or the spot
tool. If for some reason you cut too big and you want to close the gap around the puck we use
windscreen trim or window seal with 3m adhesive. Trim the seal to fit the hole and get the seam
to meet under the puck so it is less visible.
11.
Mount left side puck with 99-HB-SH10125080 Socket Cap 10 X 1.25 X 80 Main Engine Stud and
torque down to the recommended OEM torque specifications.
12.
Mount left side panel.