Shogun Motorsports Kawasaki ZX10R (08-10) Frame Slider - Manual (Page 2)

2.
Remove left side mid panel.
3.
Locate the left side engine stud and remove bolt.
4.
Some photos in this section are used for illustration examples only. It is up to you how you
decide to cut your motorcycles bodywork to accept the frame slider there are many different
ways customers go through this process.
Shogun is not responsible for any part of your
motorcycle for any reason. Precisely measure location of cut and if in doubt at any point please
call us before the install process has begun. Professional installation is recommended. Always
use proper safety measures during the install of this product. Do not try to install this product
without proper tools, recently calibrated torque wrench, correct torque specifications from
factory service manual,
safety goggles and gloves.
5.
Body Prep. Use masking tape to completely mask off the area on the body where you will be
working. We usually will tape off approximately 6 to 8 inches around the though hole area and
any other edges that could get bumped or scratched while working. Tip: In some locations you
may want to double up the thickness of the masking take to give extra protection.
6.
Locating and cutting the body. This is a simple illustration of how most of us install the product
here. It takes a bit longer but our end results have been more consistent with a better overall fit
and finish. We start with (99-SPOT-1012560) Shogun Spot tool. It’s nothing special just a 10mm
socket cap bolt with a 1.25 pitch that we cut the head off of and sharpen to a point. You can
purchase the tool for $12.99 or go to your local hardware store and make your own. Keep in
mind Metric 10 or 12mm X 1.25 pitch bolts (most common sportbike engine studs) are fairly
hard to find. Make sure you know the size and that the bolt you’re buying is a 1.25 pitch bolt.