Shogun Motorsports Honda CBR250R (11-12) NO CUT Frame Slider User Manual
Page 6
Advertising
6. Mount right side offset
(LOOSELY)
by hand using all 3 bolts. Tighten both 6 X 1.00 X 60 (99-HB-
SH0610060) socket cap bolts
(FIRST)
then main OEM engine stud. Check service manual for 6mm
and main engine stud OEM torque specs.
7. With both offsets left and right mounted and torqued down, install puck spacer (99-SP-750-
3110) and frame slider puck using 10 X 1.25 X 60 (99-HB-SH10125060) socket cap bolts. The
small diameter side of the puck spacer goes towards the offset shown below. Use one drop of
blue thread locker on puck bolts and torque down to 30 to 32ft lbs.
Advertising