Spicer Tandem Drive Axles Service Manual D170, D190, and D590 Series User Manual
Page 25
21
Power Divider
12. Assemble the sliding clutch, shift fork and fork
spring to the input shaft and install assembly into
carrier. Make sure that the shift fork rod is piloted in
the carrier bore.
Before installing input cover, inspect and thoroughly clean
mating surfaces using an appropriate solvent and clean
rag.
Note: Completely remove all old gasket material prior to
applying new Loctite.
13. Apply a bead of Loctite 518 to the carrier surface as
shown in the illustration.
14. Install input cover and capscrews. Torque to the
proper specifications. See the Torque Chart on page
D-1. Tighten fasteners in a criss cross pattern.
15. Install input shaft bearing adjuster, adjust inward
until snug against the bearing cone.
Input Shaft Endplay
16. Back off input bearing cage one notch and check
endplay. Endplay should be between 0.001" to 0.005"
(0.03 to 0.13 mm). Rotate cage in or out to get
proper setting.
IMPORTANT
190 Cover
170 Cover
1 - One Notch
1
Power Divider