Spicer Tandem Drive Axles Service Manual D170, D190, and D590 Series - Manual (Page 67)

63
Output Shaft Assembly & Rear
Cover
Measure
Correct endplay for a new assembly is 0.001" to 0.045" [0.03
to 1.143 mm]. The maximum endplay for a used assembly
is no more than 0.045" (1.143 mm). If endplay is incorrect,
contact Dana.
1. Install oil seal.
2. Install yoke.
3. Install yoke nut. One of the following options may be
utilized:
a. Install a new nut with the pre-applied thread
adhesive compound. Tighten the nut to the
specified torque. See the Torque Chart.
b. If a new nut with pre-applied thread adhesive
compound is unavailable, apply Loctite 277 or
271 (available in 0.5 ml tube—P/N 129293)
to the nut along two threads, for at least two
flats (120°) of the nut midway through the
thickness (see illustration). Tighten the nut
to the specified torque. See the Torque Chart.
Ou
tp
ut Sh
aft A
ss
em
bly &
Re
ar C
ov
er