Spicer Tandem Drive Axles Service Manual D170, D190, and D590 Series - Manual (Page 64)

60
Output Shaft Assembly & Rear
Cover
8. Remove both inner and outer bearing from output
shaft.
9. Remove output shaft inner bearing cup.
Note: Components such as the inter-axle driveline, yoke, oil
seal and output shaft assembly should have been
removed according to normal service procedures.
Removing the differential assembly from the axle
housing is not necessary, but would ease the removal
process of the inner bearing cup from the cover bore.
a. Using a bearing puller tool, remove the inner bearing
cup.
b. Visually inspect the inner-machined bore surface of
the welded-on cover for nicks and burrs. Repair if
necessary.
1
1 - Press