Remove output shaft assembly – Spicer Tandem Drive Axles Service Manual D170, D190, and D590 Series User Manual
Page 63
59
Output Shaft Assembly & Rear
Cover
Remove Output Shaft Assembly
Note: For forward axle rear covers that are removable the out-
put shaft may be removed when the cover is in or out of
the axle assembly.
1. Disconnect the inter-axle driveline at the forward
axle rear cover position.
2. Remove yoke nut (shoulder nut).
3. Remove yoke from output shaft using appropriate
tool.
TIP: A yoke puller tool may be made from the center
section of most gear puller tools, or may be pur-
chased from your tool distributor.
4. Remove oil seal.
5. Remove snap ring.
6. Remove output shaft and outer bearing cup as an
assembly.
TIP: It may be helpful to loosely reinstall the yoke
and shoulder nut giving the technician more of an
area to grip when removing the output shaft.
7. Remove the inner bearing cup from rear cover
assembly. This may be removed from inside the axle
housing when the carrier is removed, or by removal
of the forward axle rear cover.
1
1 - Yoke Puller Tool
2
1
6
3
4
5
1 - Snap Ring
2 - Outer Bearing Cup
3 - Output Shaft Assembly
4 - Inner Bearing Cup
5 - Rear Cover Assembly
6 - Output Seal
Ou
tp
ut Sh
aft A
ss
em
bly &
Re
ar C
ov
er