Program instructions location – Velleman VMB1TCW User Manual
Page 71
PROGRAM INSTRUCTIONS LOCATION
This chapter is only applicable when multiple temperature controllers are connected to your Velbus installation.
It can be skipped if you have only one controller connected.
Prior to start programming it is important to determine which temperature controller will hold the program instructions for
the rooms, zones and ‘all rooms’ to avoid that multiple controllers contain different instructions for the same rooms or
zones.
The instruction set will be available from every controller.
1. Determine the temperature controller that will hold
the program instructions for a certain room or zone.
2. On that controller, press the ‘Location’ button
repeatedly until the desired room, zone or ‘all rooms’
is displayed.
3. Press and hold the ‘Menu’ button for ±4 seconds to
open the extended menu. Enter the PIN code if
necessary.
4. Scroll through the extended menu using the
↑ or ↓
button until the ‘Sensor settings’ item appears.
5. Select the sensor settings menu with the
→ button.
6. Scroll through the sensor settings menu using the
↑
or ↓ button until the ‘Local program’ item appears.
7. Select the local program menu with the
→ button.
8. Switch on local program with the
↑ or ↓ button.
Location
↑
↓
Menu
→
Mode
←
Living room
Program
Location
↑
↓
Menu
→
Mode
←
Living room
Sensor settings
Location
↑
↓
Menu
→
Mode
←
Living room
Operating mode
Location
↑
↓
Menu
→
Mode
←
Living room
Local prog ___
Location
↑
↓
Menu
→
Mode
←
Living room
Mo 14:47 22
Location
↑
↓
Menu
→
Mode
←
Living room
Local prog On
Location
↑
↓
Menu
→
Mode
←
Living room
Local program