Velleman VMB1TCW - Manual (Page 61)

Recall and change the desired temperature
At any time the desired temperature for a room can be shown and/or changed.
1. Press the
↑ or ↓ button.
The desired temperature for the selected room is flashing on the display.
2. When desired, change the target temperature with the ↑ or ↓ button.
3. Return to normal display by pressing the
 or ← button or simply wait for ±5 seconds without touching any button.
Remark:
When switching between anti-freeze, night, day or comfort mode the target temperature will be replaced by the desired
temperature that is linked to each mode.
Temporarily switching between comfort, day, night or anti-freeze mode
In rooms equipped with a temperature sensor VMB1TS, the heating (or cooling) can be set to 4 modes (comfort , day
, night or anti-freeze -). Every mode has a preferred temperature setting.
The heating (or cooling) can be forced temporarily (sleep timer) into a certain mode. During that time, all program
instructions will be ignored. Once the timer expires the normal program is resumed or when no program was active the
device returns to the previous mode.
This could be useful e.g. to switch the heating of the bathroom to comfort mode for an hour.
Temporarily switching between the different modes is done by pushing the push button on the temperature sensor
VMB1TS or via this module.
Location

↑
↓ Menu
→
Mode
←
Living room
Target ___
Location

↑
↓ Menu
→
Mode
←
Living room
Target 21
Location

↑
↓ Menu
→
Mode
←
Living room
Mo 14:23 21