Veris Industries H84xx Install - Manual (Page 13)

Z204046-0J PAGE 13 ©2011 Veris Industries USA 800.354.8556 or +1.503.598.4564 / [email protected] 12115
Alta Labs, Enercept, Enspector, Hawkeye, Trustat, Veris, and the Veris ‘V’ logo are trademarks or registered trademarks of Veris Industries, L.L.C. in the USA and/or other countries.
TM
H84xx INSTALLATION GUIDE
SETUP
Set Up the Power Meter
1. Press -----> until you see SETUP.
2. Press SETUP. Enter your password (Default password is 00000).
3. Press + to change a digit, <----- to select the next digit.
4. Press OK.


  

 


  




 



  





Set Up CTs
1. Press CT. ----->
2. Enter the PRIM CT (primary CT) number (1 to 32767, using the + and <-----
buttons).
3. Press OK.
Set Up PTs
1. Press PT. The default is NO PT. Single Phase System types (10, 11, 12) do not allow
PTs.
2. Press +
3. Select the SCALE value: x1, x10, x100, NO PT (for direct connect).
4. Press OK.
5. Enter the PRIM (primary) value.
6. Press OK.
7. Enter the SEC. (secondary) value.
8. Press OK.
Set Up the System Frequency
1. Press -----> until HZ is visible.
2. Press HZ.
3. Press + to select the frequency: 50 Hz or 60 Hz (default is 60Hz).
4. Press OK.