V-Tech DMR18 Manual - Manual (Page 8)

Basic Tools Detail:
Item Description
Factory
set
ID Code
If only one door station is installed in this building, set
to 1;
If multi door stations are installed, primary door station
must be set to 1, and other slave door stations must
be set from 2 to 4. Note that max. 4 door stations is
available in one building
[1]
Single
Unlock Timing
To set the time that how long the door keeps open
when door is released. Range from 01 to 99 seconds.
[05]
5 seconds
Unlock Output
To set the unlock mode to match the corresponding
lock.Rand from 0 to 1
0
Card Manage
To set the card location.If set to 0,the card is saved in
door station.If set to 1, the card is saved in DT-IPC
0
Doorplate Mode
To set the calling mode.If set to 0,it's the auto
mode,that means the calling will be activated directly
after inputting 2 digits code.If set to 1,it's the manual
mode,that means you should press "#" button to
activate the calling after inputting the code.
[0]
Auto mode
Audio Options ...
To set the talking mode.If set to 0,hands free mode is
activated.If set to 1,handset mode is activated.
0
Parameters ... To show the parameters,please refer to table 2.1
Installer Code ... To change door station administrator code [66666666]
Default ...
Note this operation is irreversible. Once restore is
activated, all parameters will return to factory default
setting except the information of access card.
Table 2(Installer Setup):
-7 -