V-Tech DMR18 Manual - Manual (Page 9)

Item Description
Factory
set
Monitor Timing To show the monitor time,Range from 6s to 600s 30s
Switch Timing
To show the surveillance time for each Door Station or
CCTV camera.Range from 6s to 600s
40s
Wait Timing To show the calling wait time,Range from 10s to 600s 30s
Talk Timing
To show the limitation time of talking,Range from 10s
to 600s
90s
Monitor & Speak
To enable Indoor Monitor under monitoring state can
speak to Door Station at same time. If set to 1, talk
enabled; set to 0, disabled.
Monitor & Unlock
To enable Monitors under monitoring state can open
the door at the same time.If set to 0, unlock function
is disabled; Set to 1, unlock is enable;Set to 2,unlock
is enable and close at once;Set to 3,unlock is enable
and close in 5s.
[1]
Ring Numbers
To show ring times when door station calls monitor.4
options for choice. If set to 0, ring once. If set to 1,ring
twice. If set to 2, ring three times.If set to 3,cycle ring
[1]
NameList Display
Mode
To show the namelist display mode.If set to 0,it's the
DT-Config display mode.If set to 1,it's the Simulate
display mode
[0]
Working Mode
To show the working mode.If set to 0,it's the apartment
system mode.If set to 1,it's the villa mode.
[0]
Table 2.1(Parameters):
Note:
this section is set on DT-Config software,for more detail informations,please refer to the
DT-Config software user instructions.
-8-