V-Tech DT-IP Technical Guide - Manual (Page 56)

5. Call Table For Blocks
For DT-IPC of blocks, there is 2 call tables for calling guard station: Button Call Table and
Call Priority.
The route for Call Table(Take B Block as an example): Click right mouse button on B Block
-> Management -> Call Table, see the following picture, both of them have 2 buttons, View
& Edit and View On Device. Press View & Edit, you can view the table in the database
and edit, then can download the edited table to the corresponding DT-IPC. Press View On
Device, you can check the call table in the corresponding DT-IPC.
Button Call Table: This table is for door station and monitors calling guard centre
The table is actually a Mapping between Guard Centre and Door station/Monitor.
It’s to say:
For door station, press the specified button(DMR11) or input the specified No.(DMR18) to
call the corresponding Guard Centre.
For Monitors, press the specified No. in the Namelist to call the corresponding Guard
Centre.
1) View & Edit
Click Add Guard Centre button to pick one Guard Centre for 32
-54-
IP-2 wire system technical guide