V-Tech DT-IP Technical Guide - Manual (Page 68)

highest one.
GL Call IM: To set Priority for Guard Center calling indoor monitor.
CDS Call IM: To set Priority for Common Door Station call indoor monitor.
DS Call IM: To Set Priority for door station call indoor monitor
b. 8210 Control
IP-8210 Reset Check Number: If DT-IPC had been detected offline N times, start power-
down mode. To set the N value.
IP-8210 Power Cut Time: Timing for power-down when reset DT-IPC
IP-8210 Reset Count: Counting for DT8210 resets
c. Call Table Quan
Rows of Common Call Table: To set rows of common call table. Default is 110.
Rows of IP Table: To set rows of IP Table. Default is 32.
Rows of Room Call Table: To set rows of Room Call Table. Default is 32.
-66-
IP-2 wire system technical guide