V-Tech DT-IP Technical Guide - Manual (Page 63)

Mapping Rule
* Using Default Rule to call Guard Unit and monitors. For example, press 254-01 to call
Guard Station 1, press 243-01 to call Guard Station 3, press 024-15 to call the monitor
whose user code is 15 in D block.
* New rule for Mapping between Common Entrance and monitors
As the above CDS Input, for example, press 004-07 to call the monitor whose user code is
15 in D block after the rules are download to device.
7. Call Table for Direct Button Common Entrance Panel(DMR11)
For Direct Button Common Door Station, only Button Call Table and Call Priority should be
cared about. For Call Priority setting is similar to call Priority section in Call Table for Blocks
chapter, this chapter just focus on Button Call Table.
192.168.0.26 had been configurated to be a CDS(Common Door Station) in IP Node Config
Chapter. Assume that DMR11/D8 and EP24 had been connected to this DT-IPC.
Click right mouse button on Common Entrance and select Management, then select Call
Table button into the following interface.
-61-
IP-2 wire system technical guide