V-Tech DT-IP Technical Guide - Manual (Page 60)

Note that: for the above example, press 32 to call Default GL, calling can be diverted when
destination is busy or offline. The called Guard Centres and diverting order depend on
the info that had been stored in the corresponding DT-IPC. Press View on Device of Call
Priority to view the Guard Centre Priority. The operation for Guard Centre Priority will be
introduced in the next part.
2) View On Device
You can check the info in the DT-IPC by pressing the View On Device button
Continue previous operation, press the View On Device after Write to Device operation.
The table is as follow:
Call Priority
This Call Priority operation is only for the corresponding DT-IPC.
Because we can download the default Guard Center Priority to all the DT-IPC in the Global
Setting( eg. Click right mouse button on Benchmark Project -> Guard Center Priority), you
should firstly press the View On Device to check if the priority setting is ok. If not, press
View & Edit button entry the setting.
-58-
IP-2 wire system technical guide