Vutec LECTRIC IV - Installation Instructions - Manual (Page 2)

1
04/21/08 Rev D
LIIe-INST_D
IMPORTANT SAFETY INSTRUCTIONS
Basic safety precautions should always be followed; including the following:
♠ Read and understand all instructions before proceeding with the installation and operations.
♠ Lectric IIe and Lectric IVe meet requirement for fire-resistant and low smoke-producing
characteristics suitable for operation in a build ing’s environmental air space, such as above
suspended ceilings, in accordance with Section 300-22 (C) of the national Electric Code,
ANSI/NFPA 70, and sections 2-128, 12-010(3) and 12-100 of the Canadian Electric Code, Part 1,
CSAC22.1.
♠ Be certain that the supporting structure is sound and capable of carrying the weight as required.
♠ Seek qualified electricians to perform electrical requirements.
♠ This permanently connected projection screen must be protected by a fuse or circuit breaker.
Make sure that there is a readily disconnect devi ce incorporated on the building installation
wiring.
♠ Obtain proper lifting mechanism to raise and hold the unit steady for installation.
♠ Plan ahead so the installation can go smoothly and efficiently.
IMPORTANT WARNINGS AND CAUTIONS!
WARNING: A WARNING ALERTS THE POSSIBILITY OF SERIOUS INJURY OR DEATH IF THE INSTRUCTIONS ARE NOT FOLLOWED.
CAUTION: A C AUTION ALERTS THE PO SSIBILITY OF DAMAGE OR DESTRUCTION OF EQUIPMENT IF THE INSTRUCTIONS ARE NOT
FOLLOWED.
WARNING: FA ILURE TO REA D, TH OROUGHLY UN DERSTAND, AND FO LLOW AL L INSTRUC TIONS C AN RESUL T IN SERIOUS
PERSONAL INJURY, DAMAGE TO EQUIPMENT, OR VOIDING OF FA CTORY WA RRANTY! IT IS TH E IN STALLER’S
RESPONSIBILITY TO MAKE SURE ALL COMPONENTS ARE PR OPERLY ASSEMBLED AND INSTALLED USING THE
INSTRUCTIONS PROVIDED.
WARNING: FAIL URE TO INSTA LL EL ECTRICAL REQ UIREMENTS AC CORDING TO NATIO NAL/LOCAL EL ECTRICAL CODES AND
REGULATIONS MAY CAUSE PREMATURE FAILURE, FIRE HAZARD, ELECTRICAL SHOCK, UNSAFE PRACTICE AND
REVOCATION OF USE.
DISCLAIMER
Vutec Corporation intends to m ake this m anual accurate and com plete. However, Vutec m akes no claim that the
information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency
in connection with the installation for use of t his product. The information contained in this document is subject to change
without not ice. Vut ec m akes no representation of warranty, expressed or i mplied, regardi ng t he i nformation cont ained
herein. Vutec assum es no responsibility for accuracy, completeness or sufficiency of the info rmation contained in this
document.
PRE- INSTALLATION
1) Carefully cut and remove packing materials.
2) Carefully unpack and inspect the unit for sign of damages.
3) Be sure to recheck and measure all pertinent dimensions before installation.
4) Most basic tools are required for installation.
SAVE THESE INSTRUCTIONS