Vutec corporation – Vutec ARTSCREEN R-SERIES - Safety Instructions User Manual
Page 10
ART-R SERIES INSTL_RevG
- 10
-
VUTEC CORPORATION
Coral Springs, FL 33065
TEL: (954) 545 9000 - FAX: (954) 545 9011
E-MAIL:
ART
ROLLER
INSTALLATION
Vutec has made a significant improvement to control and reduce the vibration noise level associated with the art roller motor.
The art roller motor is now shipped uninstalled to protect the four vibration dampers imparted in the design.
The following steps show how to install the art roller to the art screen unit.
Note: Installing the art roller motor must be the last thing to do! Therefore, the metal frame, the Plasma TV and its mounting location
must have been installed, adjusted and checked to satisfaction before proceeding with the art roller installation.
Step 1
Carefully remove the plastic wrapping. Locate two #8-32 machine screws and flat washers for used. There should be a layer
of paper protecting the art roller. Do not remove the paper until the art roller has been installed and secured properly. The
paper keeps the art print clean for final revelation.
Step 2
Referring to Figure D, insert the art roller into the idler bracket at angle as shown. Rotates and guides the art roller into place
such that it sits on the motor bracket as shown in Figure E.
Step 3
Use #8-32 by 3/8 inch long machine screws to secure the art roller in place (Figure F). Do not over-tighten the screws.
Step 4
No placement adjustments are necessary because the location of the idler bracket has been determined and it remained on the
metal frame for this purpose.
Step 5
Connect the motor cable to the IR control box.
Step 6
Remove the masking tapes and the protective paper. The art roller is ready for operation!
Figure D
Art
roller
insertion
Figure E
Art roller in place
Figure F
Screw
attachment