Vutec ARTSCREEN R-SERIES - Safety Instructions User Manual
Page 4
ART-R SERIES INSTL_RevG
- 4 -
VUTEC CORPORATION
Coral Springs, FL 33065
TEL: (954) 545 9000 - FAX: (954) 545 9011
E-MAIL:
Press the Power to ON (1) on X-Arm Control Box on side of Main Shell (See Figure 2).
Manually keep Art rolled up limit switch LS1 actuated. LS1 is shown in Figure 13 on this manual. Press “Power” and then “X-Arm”
button on the X-Arm remote control to bring Arm forward. Let go LS1.
The TV is very heavy. Use at least two people to hang TV on X-Arm.
Hang the TV on the top bar of X-arm and then carefully rotate it down as shown in Fig. 8.
Center TV to Main Shell by sliding TV sideways as necessary, clearances dimensions must be same in both sides of TV,
as shown in Fig 10. Check top and bottom clearances, bottom clearance could be a little larger than top.
Insert each of the four safety clips, on the top and bottom of the TV Mounting Bracket (Hook brackets) as shown in Fig. 9
Secure the safety clips using the included hex wrench to tighten the screws.
Actuate Art rolled up
limit switch LS1 once
again to activate power
and press “X-Arm”
button on X-Arm remote
control to recede X-Arm.
Check TV width and
Calibrate TV
following instructions
on pages 11 and 12 of
X-Arm user manual.
Figure 8
Hang TV on X-Arm
Figure 9
Insertion of safety
clips
Figure 10
TV centered on
Main Shell