Vutec HD III - Installation Instructions - Manual

VUTEC II & HD III
WALL OR UNDER CEILING MOUNT
GENERAL
The VUTEC II or HD III screen may be mounted to the wall or ceiling as shown in Figures 1 and 2. The screen
comes with three mounting brackets and screws. Where possible, the mounting brackets should be installed to rigid
structural members. If this is not possible, suitable wall anchors or other mounting methods must be considered.
Figure 1 Figure 2
Wall Mounted Ceiling Mounted
Important considerations when deciding the mounting
location for the screen.
¾
The Housing Length (Figure 3) is as follow:
Housing Length = Viewing Width + 10 1/4 (Lectric I)
¾ The screen is centered in the housing.
¾ The housing may be moved left or right after it has been
hang for final location.
INSTALLATION
Determine the housing length and Dim. K. A third mounting
bracket is recommended for middle support for screen of
96 inches viewing width or larger.
Dim. K should be approximately 1/6 to 1/8 of Housing Length.
Install the mounting brackets as required. Be sure they are level
and in-line for proper contact with the housing.
Note: If the screen is wall mount, the mounting brackets must
be at least 1 1/2 inches from the ceiling as shown in Figure 1. If
the screen is ceiling mount, the mounting brackets must be at
least 4 3/4 inches from the wall (Figure 2).
Back-off the locking screw for each mounting bracket so that it
is even with the inside face of the bracket.
Slightly tip the screen housing and fit it into the mounting
brackets. If this is a ceiling installation, move the screen
housing toward the rear immediately after the insertion so the
screen is completely hooked to the brackets (see Figure 2).
Figure 3