Vutec HD III - Installation Instructions - Manual (Page 2)

Carefully move the screen housing side to side for desired location.
Tighten the locking screw of each bracket to lock the screen in place.
OPERATION
This is a manual pull down screen on a spring-loaded roller. There is only one stop for each revolution of the roller
which causes the screen to travel approximately 10 inches.
There is a maximum of 12 inches of black leader unless otherwise specified. Depending on the lowest stop of the
roller; there may not be full 12 inches of black leader exposed.
If the vertical location of the screen – the viewing area does not coincide with projected image; then, do one of the
following:
- Determine how much up or down distance for the screen then re-mount the screen accordingly.
- Adjust the pitch of the projector and the keystone feature as necessary.
SHOW POSITION:
Pull the screen down to desired location but not past the “WARNING” label on the screen. SLOWLY let back
and the roller lock will catch and stop the screen.
If there is at least 3 inches of black leader exposed on the last stop; then, there is not enough travel to pull the
screen down any further!
RETRACTED POSITION:
Pull the screen down approximately 4 to 6 inches with a fast motion, then quickly guide it back up with a smooth,
non-hesitating motion.
CAUTION: DO NOT LET THE SCREEN FLY UP!
Hint: the fast motion of pulling down will cause the catch to fly open for the screen to come back up. Quickly
guide the screen up to ensure that the catch stays open and not letting it back in the locking position.
Note: it has been determined that some users experienced difficulty trying to send the screen back up. Vutec
assures that this problem is not a mechanical defect; it is simply requires practice and familiarity of the product.
ACCESSORIES INCLUDED
3 MOUNTING BRACKETS WITH SCREWS