Printronix SL5000r RFID Smart Label and Thermal Printers - Manual (Page 377)

377
Symbols
^Dnn Dot Slew option, 193
Numerics
06 HOST REQUEST fault message, 317
08 HOLD PRINT TIMEOUT fault message, 317
1284 parallel interface, 295
15 COMM CHECK fault message, 317
20 CPI Condensed option, 193
203 DPI fault message, 318
22 INVALID ADDR fault message, 317
27 CU TIMED OUT fault message, 317
28 CU NOT ENAB fault message, 317
300 DPI fault message, 318
33 HEAD OPEN Timeout fault message, 318
40V POWER FAIL fault message, 318
5225 World Trade option, 193
A
Absorb After ^PN option, 193
Absorb After ^PY option, 194
Accessories, 355
ACK / NAK, 247
Acoustic noise levels, 351
Active Char Set option, 194
Active IGP Emul option, 150
Active IGP Emulation option, 114
Admin User option, 155, 159
Advanced gap, 71
Advanced notch, 71
AI 00 Spaces option, 194
Alarm option, 152
Alarm, printer, 316
Alt. Char Set option, 194
Alt. Set 80-9F option (Coax, Twinax, TN3270,
TN5250), 195
Alt. Set 80-9F option (P-Series, Serial Matrix,
Epson FX), 194
Ambient light Validator failure fault message, 318
Amp-Hour Used option, 275
Ant. Diversity option, 266
Antenna option, 266
Append Rotated option, 195
ASCII Data Port option, 259
Auth Method option, 267
Auth Method, WLAN EAP menu, 272
Auto Calibrate option, 113, 139
Auto calibrate, running, 72
Auto FF at ^PN option, 195
Auto Label Width option, 128
Auto LF option (P-Series, P-Series XQ), 195
Auto LF option (Serial Matrix, Proprinter XL, Epson
FX), 195
Auto Locking option, 155
Auto Map Select option, 125
Auto Save Configuration, 89
Auto Save option, 117
Auto Skip at End option, 196
Auto switching, 293
Auto Trickle option, 243
Auto Uppercase option, 196
Autoeject option (VGL), 196
Autowrap option, 196
B
BAD VFU CHANNEL fault message, 318
BAR CODE IMPROPER Data Format fault
message, 318
Index