Velleman UTP05 - Manual (Page 10)

Atlas IT User Guide October 2012 – Rev 6
Page 9
Analysis Results
Good Cables
If the cable being tested is good, the Atlas IT will display a message similar to
this:
The first page to be displayed tells you the
type of connection configuration for the
cable you’re testing, in this case a simple 8-
wire patch cable (straight-through).
The arrow on the bottom-right of the display reminds you that more
information is available on the next page, briefly press scroll-off when you’re
ready.
The next information to be displayed is the confirmation of the full connection
pattern between the terminator “
Term” and the Atlas IT “Atlas”:
As can be seen from the display here, the
connections are verified as being those
relating to a normal straight through patch
cable. The connections between the Atlas
IT Terminator end of the cable are shown
together
with the corresponding
connections on the Atlas IT end of the network cable.
The displayed cable type and connection
pattern depends on the type of cable being
analysed of course, as a further example
the following would be displayed for a
good 8-wire crossover cable: