Rough Country 352 - Manual (Page 4)

Thank you for purchasing a Rough Country Leveling System.
KIT COMPONENTS
Rear Spacers
Front Strut Spacers
8. Install the spring spacer and secure with the supplied
3/8” x 2 1/2” bolt through the upper flat retainer to hold
the spacer in place. Tighten using a 14mm Socket &
wrench. See Photo 13.
9. Reinstall the coil spring.
10. Lift the axle with the floor jack and reinstall the stock
shocks with the stock hardware using a 21mm wrench.
11. Reinstall the sway bar link on the sway bar using a
18mm and 8mm wrench.
12. Reinstall the tires /wheels and remove the jack stands.
13. Lower the vehicle to the ground.
POST INSTALLATION
1. Check all fasteners for proper torque. Check to ensure there is adequate clearance between all rotating, mobile,
fixed and heated members. Check steering for interference and proper working order. Test brake system.
2. Perform steering sweep. The distance between the tire sidewall and the brake hose must be checked closely. Cycle
the steering from full turn to full turn to check for clearance.
3. Re torque all fasteners after 500 miles. Visually inspect components and re torque fasteners during routine vehicle
service.
4. Readjust headlights to proper settings and take truck in for a front-end alignment to a qualified alignment
professional.
KIT CONTENTS:
2-Front Strut Extensions
1-3/8 Bag that includes:
6-3/8” Studs
6-3/8” Nuts
6-3/8” Lock Washers
2-Rear Coil Spacers
1-359Bag2 Includes:
2-3/8” x 2 1/2” Bolts
2-3/8” Nylock Nuts
4-3/8” Flat Washers
PHOTO 13
Rear Spacer Retainers