Rough Country 352 - Manual (Page 6)

CAB INSTALLATION INSTRUCTIONS
1. Raise hood disconnect positive and negative battery cable from the battery using 10mm wrench. This is done be-
cause of airbags. Check owners manual and remove airbag fuses to prevent accidental air bag deployment.
2. Remove clips holding radiator bezel by pulling up on bezel at each clip using pliers if needed. See Photo 1.
3. Remove four bolts holding grill on using 10mm pull on lower part of grill to remove from truck. See Photo 2.
4. Remove two bolts from headlights using 10mm. See Photo 3. Remove clip from inner fender well to gain access to
rear of headlamp. See Photo 4.
5. Push up on clip as seen in Photo 5 to release the headlight.
6. Unplug all wires and remover the headlamp from the truck. See Photo 6. Repeat for other side.
PHOTO 1 PHOTO 2
PHOTO 3 PHOTO 4
PHOTO 5 PHOTO 6
REMOVE RADIATOR BEZEL CLIPS REMOVE THE GRILL BOLTS
REMOVE HEADLIGHT BOLTS REMOVE CLIP FROM FENDER WHEEL
HEADLIGHT RELEASE SHOWN REMOVE WIRES FROM HEADLIGHT