Rough Country 352 - Manual (Page 7)

7. Remove painted bumper cover using 10mm and 8mm socket. There are 8 bolts 1 behind each headlamp and four
on bottom of bumper and 2 bolts ( 8mm )on inner fender well. See Photo 7 & 8.
8. Remove clips that attach bumper to inner fender well (4 of these). See Photo 9. On topside of bumper there 9 tabs
that must be unclipped. See Photo 10.(Models with chrome bumper will not have 4 bolts on the bottom or clips on
fender wells). Remove the bumper cover from the vehicle.
9. On driver side unplug and pull connector off of bumper above fog lamp. Then remove 6 nuts from bumper using
18mm wrench. (3 on each side). See Photo 11 & 12.
PHOTO 7 PHOTO 8
PHOTO 9 PHOTO 10
PHOTO 11 PHOTO 12
REMOVE THE BUMPER COVER
REMOVE BUMPER BOLTS
REMOVE THE INNER FENDER UNCLIP TABS ON BUMPER
UNPLUG FOG LAMP CONNECTORS REMOVE BUMPER BOLTS