Banks Power Chevy_GMC Trucks: Duramax LB7 (Diesel ’01 - 04 6.6L) Tuner- Six-Gun Diesel Tuner with optional Speed-Loader Module '01-04 For use with Six-Gun Switch - Manual (Page 18)

18
96446 v.4.0
31.
Install the 4-pin connector of
Speed-Loader harness to the 4-pin
connector on the Speed-Loader
module.
32.
Verify the Banks wire harness, Six-
Gun Diesel Tuner and Six-Gun switch
are installed as specified in the
Owners Manual. Disconnect the Six-
Gun Switch from Banks Wire harness.
33.
Connect the Six-Gun switch’s 2-
pin receptacle to the Speed-Loader’s
2-pin plug. Connect the Speed-
Loader’s 2-pin receptacle to the Banks
Wire harness.
34.
If necessary, wire tie the Speed-
Loader module and harness under the
dash away from pedals or any moving
components.
NOTE: The optional Speed-Loader
provides access to an additional power
level of the Six-Gun Diesel Tuner. Installing
the Speed-Loader will allow levels 2
through 6 to experience an increase in
power above that of the Banks Six-Gun
Diesel Tuner alone. Level 1 remains at
stock power output regardless if the
Speed-Loader is installed. Once the
Speed-Loader is installed and detected,
the green LED on the Six-Gun connector
will flash twice at powerup. Refer to the
following “SPEED-LOADER LEARNING
SEQUENCE” section for more details.
Speed-Loader Learning
Sequence
Once the Speed-Loader Module is
installed or removed from the vehicle,
the following learning sequence (A1-
A4) will need to be performed so that
the Six-Gun Diesel Tuner can correctly
identify that the Speed-Loader is
present or absent.
A1. Start the engine
A2. Turn the Six-Gun switch to the
highest level (position 6) and stay
there for five (5) seconds.
A3. Rotate the switch to the lowest
level (position 1) and stay for five (5)
seconds.
A4. Rotate the switch again to the
highest level (position 6) and stay
there for five (5) seconds.
NOTE: To determine if the Banks Six-Gun
Diesel Tuner is running the Speed-Loader
programming, watch the green LED on
the tuner and turn the ignition switch to
the ON position (BUT DO NOT START THE
ENGINE). If the green LED flashes, the
Banks Six-Gun Diesel Tuner will run with
the Speed-Loader programming. If the
green LED doesn’t flash, the Banks Six-
Gun Diesel Tuner will run the standard
programming. If the green LED does not
indicate the same status as your Six-Gun
and Speed-Loader setup, repeat the
above steps (A1 through A4).s
-END, SECTION 5-
Section 5
OPTIONAL SPEED-LOADER MODULE INSTALLATION
(FOR OFF-ROAD, SHORT DURATION USE ONLY)