Banks Power Chevy_GMC Trucks: Duramax LB7 (Diesel ’01 - 04 6.6L) Tuner- Six-Gun Diesel Tuner with optional Speed-Loader Module '01-04 For use with Six-Gun Switch - Manual (Page 4)

4
96446 v.4.0
Dear Customer,
If you have any questions
concerning the installation of
your Banks Six-Gun Diesel Tuner,
please call our Technical Service
Hotline at (888) 839-2700
between 7:00 am and 5:00 pm
(PT). If you have any questions
relating to shipping or billing,
please contact our Customer
Service Department at
(888) 839-5600.
Thank you.
The Banks Six-Gun Diesel Tuner has
6-power levels adjustable by the
supplied Six-Gun switch.
The optional Speed-Loader module can
be added to the Six-Gun for off-road use
only to increase the power output of
Levels 2-6. Level 1 is stock with or
without the Speed-Loader installed. Each
additional higher level adds
approximately 20% of the available
power increase.
To prevent factory torque converter
damage, Banks recommends that
automatic vehicles do not exceed
Level 4 (Level 3 with Speed-Loader)
while the vehicle is experiencing load
(towing, climbing a steep grade,
carrying a load, etc.). To protect the
factory clutch, manual transmission
vehicles should not exceed Level 3
(Level 2 with Speed-Loader) if the
vehicle is loaded.
To use the higher levels of the Six-Gun
Diesel Tuner while towing or climbing,
airflow improvements must be made
to lower the exhaust gas temperature
(EGT) entering the turbo. The EGT
should not exceed 1400º for more
than a few seconds. Elevated EGT can
damage the turbocharger and the
engine.
Also, the factory clutch or torque
converter will need to be upgraded to
an aftermarket unit that can handle
the increased torque and horsepower
of the higher levels.
Failure to upgrade the clutch or torque
converter prior to using the upper
levels while the vehicle is loaded may
result in damage to the factory clutch
or torque converter. Banks is NOT
responsible for clutch, torque
converter and/or transmission
damage.
Attention!
Before proceeding
with these instructions, please
carefully read the DISCLAIMER OF
LIABILITY and LIMITATION OF
WARRANTY statement located on
page 2 of this manual.