Banks Power Ford Trucks: (Diesel ’99 - 03 7.3L Power Stroke) Exhaust- Monster Exhaust, Single Passenger side exit (w_ cat) '99-03 F-250 & F-350 User Manual
Page 11
96436 v.7.0
11
16.
For Standard Cab long-bed
vehicles: it will be necessary to cut
4
3
⁄
4
” off the rear intermediate pipe
supplied in the kit. the hanger will be
removed with the unused portion of
the pipe (see Figure 7). install the rear
intermediate pipe.
For Super-cab short-bed: install the
rear intermediate pipe as supplied (no
cut required).
For Crew-cab short-bed: install
the rear intermediate pipe. place
a 4” clamp on the end of the rear
intermediate pipe and install the
extension pipe kit (p/n 53516).
For Super-cab long-bed: remove
the rear frame mounted hanger (see
Figure 2) and install the supplied
frame mounted hanger in its place,
using the two 8mm x 30mm hex
bolts supplied and re-using the two
8mm nuts previously removed. install
the rear intermediate pipe. place
a 4” clamp on the end of the rear
intermediate pipe and install the
extension pipe kit (p/n 53517).
For Crew-cab long-bed: install the rear
intermediate pipe. place a 4” clamp on
the end of the rear intermediate pipe
and install the extension pipe kit (p/n
53518).
17.
install the single pin front
hanger clamp onto the rear of the
intermediate pipe with the hanger
pin on the inside facing the muffler.
insert the hanger pin into the vehicle’s
rubber grommet. install the inlet of
the banks Monster muffler to the
intermediate pipe. install the dual pin
rear hanger clamp onto the outlet of
the Monster muffler with the hanger
pins on the inside, facing the muffler.
insert the two hanger pins into the
vehicle’s rubber grommets. orient the
muffler such that the banks logo is
visible from the passenger side.
Figure 6