Banks Power Ford Trucks: (Diesel ’99 - 03 7.3L Power Stroke) Exhaust- Monster Exhaust, Single Passenger side exit (w_ cat) '99-03 F-250 & F-350 User Manual
Page 15
96436 v.7.0
15
24.
be certain battery ground cables
have been disconnected.
25.
locate the engine control unit
(eCu) under the dash toward the left-
hand side of the vehicle. it will be
housed in a black plastic box bolted to
the side of the vehicle. loosen the bolt
attaching the electrical connector to
the eCu on the engine compartment
side. this will be the connector closest
to the left front fender. see Figure 11.
26.
loosen the two 7mm hex bolts
on the rear portion of the black plastic
box. remove the box and eCu from
the vehicle together. pull the eCu out
of the plastic box.
27.
note the code printed on the
plastic cap on the back of the eCu.
this code should compare to the
code printed on the banks ottoMind
box label. pry the plastic cap from
the rear of the eCu using a small
screwdriver, exposing the printed
circuit board edge connector inside.
retain the plastic cap. the connector
will be coated with grease and a clear
silicone type coating, which must be
completely removed before installing
the banks ottoMind engine calibration
module.
Section 2
BANKS OTTOMIND
®
INSTALLATION (GIT-KIT INSTALLATION)
Figure 11