Banks Power Ford Trucks: (Diesel ’99 - 03 7.3L Power Stroke) Exhaust- Monster Exhaust, Single Passenger side exit (w_ cat) '99-03 F-250 & F-350 User Manual
Page 8
8
96436 v.7.0
4.
on the passenger side of the
vehicle, temporarily remove the
manifold absolute pressure (Map)
sensor (Figure 3) from its mounting
location by removing the three nuts
from the mounting studs. save the
nuts for reinstallation later. set the
Map sensor out of the way by resting
it in the intake valley of the engine.
5.
remove both driver- and
passenger-side boost tubes and
the intake plenum from the vehicle
to allow access to the rear of the
turbocharger.
6.
Disengage the exhaust
backpressure control rod by sliding
the cover on the end of the rod back
toward the turbocharger and pulling
the rod downward. this rod is below
the turbine housing; it is not the
wastegate actuator rod that runs
across the top of the turbocharger.
Note: the exhaust backpressure
control rod must be left in its place
and will not be reconnected. Do Not
attempt to secure the rod or bend in
any manner as this may cause oil to
leak from pedestal.
7.
locate the engine lifting hook
at the rear of the engine on the
passenger side, bolted to the cylinder
head. remove the lifting hook. this will
allow clearance for the installation of
the power elbow. it is not necessary to
re-install the hook.
Figure 3