Banks Power Twin-Turbo: Forced Induction- Twin Turbos Small Block Chevy User Manual
Page 15
Advertising
96800 v.1.0
15
8.
Install the
3
⁄
8
" tube onto the elbow
fitting in the block and route forward
to the front of the intake manifold.
Install the T-fitting assembly on the
end of the tube. Only tighten finger
tight.
9.
Install the long tube onto the -4
male fitting on the right side
turbocharger and route to the T-fitting.
10.
Install the short tube onto the -4
male fitting on the left side
turbocharger and route to the T-fitting.
Note: Lines may be sprung apart or
bent slightly with light thumb pressure
to install the T-fitting. All hardline
assembly tube nuts should be left
finger tight until all tubes are in place
and final adjustments for best tube fit
is complete. See
Figure 15.
-END, SECTION 4-
Figure 14
Advertising