Banks Power Twin-Turbo: Forced Induction- Twin Turbos Small Block Chevy - Manual (Page 19)

96800 v.1.0
19
6.
Unbolt the drain tube from the
turbocharger. Slide two spring band
clamps onto the hose. Install the hose
on the pan fitting and then push the
drain tube into the hoses.
7.
Reinstall drain tubes. After bolts are
installed, torque each bolt to 15-18
ft-lbs.
8.
Use pliers to expand the spring
band clamps and locate each clamp
1 ⁄ 4 ” in from each end of the hose.
When completed, repeat step 6 and 7
and install hose and clamps on left
side drain tube. See
Figure 19
-END, SECTION 5-
Figure 19