Banks Power Twin-Turbo: Forced Induction- Twin Turbos Small Block Chevy - Manual (Page 6)

6
96800 v.1.0
1.
Apply a small amount of anti-seize
onto the threads of the twelve 3 ⁄ 8 -16 x
3" bolts. See Figure 1. Install two lock
washers on each bolt.
Note: Lock washers may be supplied
already cemented together. If not,
install two washers per bolt with the
course serrations facing each other.
2.
Install each manifold with the heat
shield between the manifold and the
cylinder head using the two outside
bolts. Peel the protective covering off
of the heat shield before installation.
See
Figure 2.
3.
Install the remaining 10 bolts, finger
tight.
4.
Make an initial pass torqueing each
bolt to 15 ft-lbs. Then make a final
pass torqueing each bolt to 35 ft-lbs.
-END, SECTION 2-
Section 2
EXHAUST MANIFOLD INSTALLATION
Figure 1