Banks Power Cummins Motorhomes: (Diesel ’03 - 07 ISB-CR 5.9L) Tuner- EconoMind Diesel Tuner, Class-A w_Allison 3000MH '03-07 Compatible with Optional PowerPDA & Dynafact Gauges - Manual (Page 23)

96420 v.5.0
23
1.
Locate the Diagnostic Port Harness
in your kit. Locate the round diagnostic
port in your coach. The diagnostic port
is located either:
a) Pushers- Inside the engine
compartment or to the rear of the
engine, accessible from the outside.
b) Pullers- Inside the coach, under the
dash or in the engine compartment,
accessible from the outside.
2.
Remove the protective cap
from the diagnostic port. connect
the Diagnostic Port Harness to the
vehicle’s diagnostic port. The Harness’
connector is keyed, so it can only
go on one way. The Harness’ locking
ring may have to be rotated to allow
the connector to seat all the way into
position. Turn the Harness’ connector
locking ring clockwise (to the right)
until you feel it lock. There may
be some resistance when rotating
the locking ring into the locked
position. Make certain the connector
is locked and secured. Install the
Banks’ Protective cover to the stock
protective cap and twist them until
they lock. This will help keep dirt and
debris out of the caps.
Note: Depending on the diagnostic
port’s location, there may or may not
be a protective cap.
-END SEcTION 5-
Section 5
Installation of Diagnostic Harness