Banks Power Cummins Motorhomes: (Diesel ’03 - 07 ISB-CR 5.9L) Tuner- EconoMind Diesel Tuner, Class-A w_Allison 3000MH '03-07 Compatible with Optional PowerPDA & Dynafact Gauges - Manual (Page 3)

96420 v.5.0
3
1.
For ease of installation of your
Banks EconoMind Diesel Tuner,
familiarize yourself with the procedure
by reading the entire manual before
starting work. This manual contains
36 pages of copy, illustrations and
parts listing. If any pages are missing
from this manual please call Gale
Banks Engineering immediately for a
replacement.
2.
The exploded illustrations provide
only general guidance. Refer to each
section diagram in this manual for
proper instructions.
3.
Throughout this manual, the
left side of the vehicle refers to the
driver’s side, and the right side refers
to the passenger’s side of the vehicle.
4.
Throughout this manual, pushers
refers to the engine in the rear, and
pullers refers to the engine in the front
of the vehicle.
5.
Disconnect the ground cable from
the battery before beginning work. If
there are two batteries, disconnect
both.
6.
Route and tie wires and hoses
a minimum of 6 inches away from
exhaust heat, moving parts and sharp
edges. clearance of 8 inches or more
is recommended where possible.
7.
During installation, keep the
work area clean. If foreign debris
is transferred to any Banks system
component, clean it thoroughly before
installing.
8.
If you purchased the Banks
PowerPDA ® , then the Palm Tungsten
E2 will need to be charged for a
minimum of 1-2 hours before the
Banks software can be installed.
Locate the supplied Ac outlet wall
charger, also located in your kit
and plug the charging cord into the
Tungsten E2. Please refer to the Banks
PowerPDA Software & Installation
Kit Owners Manual for additional
instruction.
WARNING
:
The PDA may be
susceptible to damage as a result
of extended exposure to sunlight,
heat or extreme cold. It is highly
recommended that the PDA
be removed from its mounting
location if the vehicle will be
subjected to high concentrations
of sunlight, heat or cold for
an extended period of time.
Gale Banks Engineering is not
responsible for damage to PDAs
resulting from exposure conditions.
General Installation Practices