Banks Power Cummins Motorhomes: (Diesel ’03 - 07 ISB-CR 5.9L) Tuner- EconoMind Diesel Tuner, Class-A w_Allison 3000MH '03-07 Compatible with Optional PowerPDA & Dynafact Gauges - Manual (Page 28)

28
96420 v.5.0
1.
Locate the universal mount and
docking station in your kit. Interlock
the docking station to the universal
mount by inserting and sliding the
universal mount tabs into the docking
station grooves. See Figure 20.
2.
Find a smooth, flat surface suitable
for ease of access and viewing of the
PowerPDA. Loosen both knobs and
move the swivel suction plate and
docking station to achieve desired
viewing angle of the PowerPDA
screen. Do a test fit and note the
angle necessary to achieve the correct
viewing angle.
Note: There may be a snug fit when
installing the PowerPDA into the
docking station. Take care not to force
this process.
3.
Tighten both knobs to lock in the
position (Figure 20).
Note: If the universal mount swivel
does not move or is tight after
loosening the hold down knob, then
remove the previously inserted
docking station and slightly loosen the
tension screw. See Figure 21.
4.
Locate the alcohol swab in the
kit. clean the suction cup and the
mounting area and let dry. With the
suction lever in the up position ensure
the suction cup is flat against the
windshield or smooth, flat surface.
Then, push the suction lever down to
secure in place.
5.
connect the cab Harness
connector to the PDA cable. Plug the
RJ12 connector (phone like connector
at one end of the PDA cable) into one
of the receptacles in the base of the
PDA docking station.
6.
Install the Banks PowerPDA into
the docking station. Be sure the
PowerPDA is completely seated in
the docking station against the lower
support bracket.
Note: There may be a snug fit when
installing the PowerPDA into the
docking station. Take care not to force
this process.
7.
Plug the docking station’s charging
cable (seen in Figure 20) into the
charging receptacle on the lower edge
of the PowerPDA. Attach the PDA hub
to a smooth, flat surface suitable for
ease of access and viewing.
WARNING: The charging cable on
the docking station is designed
to supply a constant low-voltage
power source (+5vdc) to the
Banks PowerPDA and is “live” as
long as the system’s Diagnostic
Port Cable is completely installed
and the RJ12 connector is
plugged into the docking station.
Although this charging cable is
short and its circuitry is fuse
protected, the user is expected
to take appropriate measures
to prevent small children and/or
pets from contact with any part
of this system.
8.
Route all wiring away from any
pedals or other moving components.
Using the cable ties supplied, secure
the wiring under the dash.
9.
Double check everything to make
sure it is securely fastened and it
is not near any hot or moving parts
before starting engine.
10.
Set up the Banks PowerPDA
according to it’s instructions.
11.
Proceed to Section 10.
WARNING: The PDA may be
susceptible to damage as a
result of extended exposure
to sunlight, heat or extreme
cold. It is highly recommended
that the PDA be removed from
its mounting location if the
vehicle will be subjected to high
concentrations of sunlight, heat
or cold for an extended period
of time. Gale Banks Engineering
is not responsible for damage to
PDA’s resulting from exposure
conditions.
-END SEcTION 9-
Section 9
Mounting the Docking Station and Connecting the
Banks PowerPDA