Banks Power Dodge Trucks: (Diesel ’98 - 02 5.9L Cummins ISB) Power Systems- Stinger & Git-Kit Systems (does not connect to pump wire) - Manual (Page 16)

(1) Two times flashing RED LED
(2) One time quick flashing GREEN LED
(3) Three times flashing RED LED
(4) One time longer flashing GREEN LED
The above flashing sequence will
repeat continuously. When the
problem is corrected, the diagnostic
code will be eliminated and replaced
by a steady green light. If problem
persists, contact Banks Technical
Service.
ottomind mounting
56.
After confirming the
functionality of the system, make
sure all the mounting surface is
clean and free of dirt and oil before
mounting the OttoMind. clean
and dry as required using a cloth
dampened with rubbing alcohol or
similar cleaning solution.
caution: do not spray fluid
directly onto any electrical
equipment, or equipment
damage may result.
Mount the OttoMind on the back
of the lower dash panel as shown
in Figure
11 by peeling off the
protective backing off the adhesive
tape on the back of the OttoMind
box. Note: The OttoMind may not
clear the steering structure if it
mounted differently.
57.
Hold the module against the
panel for approximately 1 minute
while applying pressure to allow the
adhesive to properly adhere to the
surface.
58.
Re-install the lower dash panel
with the original 3 bolts. Route all
wiring away from any pedals or
other moving components. Using
the cable ties supplied, secure the
wiring under the dash. Reinstall the
trim panel. Secure all wiring under
the hood away from heat sources
or sharp edges. Your Banks product
installation is complete.
Figure 11
16 |
9 6 7 6 5 v . 5 . 0