Banks Power Dodge Trucks: (Diesel ’98 - 02 5.9L Cummins ISB) Power Systems- Stinger & Git-Kit Systems (does not connect to pump wire) - Manual (Page 3)

Tools Required:
These tools are necessary for all levels of
installation unless otherwise specified.
• 1⁄4” and 3⁄8” drive ratchets with
inch and metric sockets
including 5⁄16”, 7⁄16” deep 1⁄4” drive
sockets and a 1⁄4” drive extension
• Inch and metric combination or
open-end wrenches
• Standard and Phillips head
screwdrivers
• Standard and needle-nose pliers
• Pocket or X-Acto knife
• Clean shop towels or rags
• Drill motor*
• Tap handle*
• 3⁄16” and 7⁄16” drill bits*
• 1⁄4” NPT tap*
• Heat gun (suggested) or
cigarette lighter
• Pry bar or large groove-joint
(water pump) pliers
• Wire crimping/stripping tool
• Oxy-acetylene torch or
reciprocating saw
• Anti-seize compound
Highly recommended tools
and supplies (not applicable to
all system levels):
• Inch-pound and foot-pound
torque wrenches
• Compressed air source and hose*
•Air pressure regulator*
• Rubber tipped air blow gun*
• Multimeter or 12-volt test light
• Penetrating oil or light lubricant
spray
* Stinger installation only
9 6 7 6 5 v . 5 . 0
| 3