Banks Power Dodge Trucks: (Diesel ’98 - 02 5.9L Cummins ISB) Tuner- Big Hoss Diesel Tuner (connects to pump wire) - Manual (Page 13)

96759 v.4.0
13
Insert the black twist connector on
the wire loom and the black 2-pin
connector on the thermocouple lead
wire provided through the grommet
from the engine compartment side.
14.
At the front of the intake manifold,
remove the three bolts holding the
throttle bracket assembly to the head.
Move this assembly toward the driver’s
side battery. This will allow easier
access to the fuel pump wiring.
15.
Locate the two BLACk wire
sheaths covering four BLACk wires
at the top back portion of the fuel
injection pump. See Figure 5.
CAUTION: It is very important
that you select the proper wire.
The Banks Big Hoss Module will
not function properly if installed
incorrectly.
16.
Locate a BLACk wire tap
connector and a packet of dielectric
grease in the Banks kit. Squirt a
generous amount of the grease into
the connector and install the connector
onto the wire as shown in Figure 6.
17.
Locate the Manifold Absolute
Pressure (MAP) sensor on the
intake manifold. Unplug the factory
connector, and plug the corresponding
connectors on the Big Hoss wire loom
into the sensor and the factory wire
loom. See Figure 7.
Figure 5