Banks Power Dodge Trucks: (Diesel ’98 - 02 5.9L Cummins ISB) Tuner- Big Hoss Diesel Tuner (connects to pump wire) - Manual (Page 14)

14
96759 v.4.0
18.
Plug the corresponding male
bullet connector on the wire loom to
the installed connector on the pump.
19.
Remove three Phillips-head
screws from the trim panel below the
steering column and remove panel by
pulling directly toward the rear of the
vehicle. Toward the right side of the
opening, remove two Phillips-head
screws and install the Big Hoss Module
as shown in Figure 8.
20.
Plug the main connector from the
wire loom into the Big Hoss Module
connector. Plug the black connector
on the thermocouple lead wire into
the mating connector on the Big Hoss
Module. See Figure 9.
Route all wiring away from any pedals
or other moving components. Using
the cable ties supplied, secure the
wiring under the dash. Reinstall the
trim panel. Secure all wiring under the
hood away from heat sources or sharp
edges. For manual transmissions the
blue wire will be unused and may be
cable tied out of the way.
21.
Remove the forward bolt on the
fuel filter mounting bracket. Install the
ring terminal of the ground wire under
the head of the bolt and reinstall the
bolt. See Figure 7.
22.
Locate the gray Throttle Position
Sensor (TPS) connector just above
the injection pump. Unplug the
connector and plug both ends into the
corresponding connectors on the Big
Hoss wire loom. See Figure 9.
Note: For manual transmission
applications, proceed to Step 28.
Figure 6