Banks Power Dodge Trucks: (Diesel ’98 - 02 5.9L Cummins ISB) Tuner- Big Hoss Diesel Tuner (connects to pump wire) - Manual (Page 16)

16
96759 v.4.0
23.
on automatic transmission models,
locate the PCM (rectangular metal box
with three connectors mounted on the
passenger’s side of the firewall) in the
engine compartment. See Figure 10.
24.
Make sure that the ignition is off,
then disconnect all three connectors
from the PCM for easier accessibility
to the wires.
25.
Select the center (white)
connector and locate the wire in the
No.11 connector pin cavity. This will
typically be an ORANGE wire with a
BLACk tracer stripe. Install a T-Tap
connector on this wire approximately
2-3 inches from the white connector
body.
26.
Plug the three cable connectors
back into the PCM. The connector
bodies are indexed so they cannot be
installed in the wrong location.
27.
Locate the long BLUE wire
emerging from the middle of the Banks
Big Hoss wire loom. Route this wire
with the factory wire loom across the
base of the cowl and over to the PCM.
Plug the wire into the T-Tap installed
on the No.11 pin wire at the center
PCM connector.
28.
Reinstall the throttle bracket and
bolts removed earlier. Tighten to 18
ft-lbs. Reinstall the air filter housing on
the turbocharger.
29.
Connect the yELLOW and
RED wires of the lead wire to the
corresponding connectors on the
thermocouple. Slide the heat shrink
tubing over this connection and use
a heat gun to shrink the tubing to fit
snug over the connection.
-END, SECTION 2-
Figure 8