Banks Power Chevy_GMC Trucks: Duramax LLY-LBZ (Diesel ’06 - 07 6.6L) Intake-Techni-Cooler Intercooler '06-10 User Manual
Page 4
4
96786 v.4.0
5.
Remove the inner fenderwell.
2006-07 LBZ: Remove the 8 pushpin
fasteners and 2 large head plastic
fasteners that attach both driver’s and
passenger’s side fenderwell.
07-10 LMM: Remove the 6 pushpin
fasteners and (4) 7mm and (1)
10mm bolts from both driver’s and
passenger’s side fenderwell.
Note: ALL YEARS the fasteners are
accessed through the wheel arch
opening. Pull the fenderwell down
approximately 6 inches once the
fasteners are removed. Disconnect the
wire harness retaining clips on top of
the fenderwell, and then remove the
fenderwell from the vehicle.
6.
Disconnect connectors from
headlamp assemblies and remove
headlamp assemblies.
2006-07 LBZ: Rotate the headlamp
retaining pin, then remove the pin
as shown in Figure 3. Disconnect
the connectors from the backside
of the headlamp assembly, and
remove both driver’s and passenger
headlamp assemblies from the vehicle.
Next, remove the park/turn signal
lamp assembly by depressing the
outboard retaining clip, then rotating
the assembly outward as shown in
Figure 4. Remove the bulbs from the
turn signal lamp assembly by turning
the lamp sockets a quarter turn
counterclockwise.
Note: the headlamp is easily
disengaged and does not require force
to be removed once the outboard clip
has been depressed.
07-10 LMM: The headlamp assembly is
secured with 3 bolts. Remove the bolts
to the headlamp assembly.
Attention: Number and location of bolts
on the headlamp assembly may vary by
model and year.
Figure 2 Removal of Push-In Retaining Pins