Banks Power Chevy_GMC Trucks: Duramax LLY-LBZ (Diesel ’06 - 07 6.6L) Intake-Techni-Cooler Intercooler '06-10 - Manual (Page 8)

8
96786 v.4.0
10.
Remove the low pressure A/C
condenser line from the line retainer
attached to the upper fan shroud.
11.
Remove the upper section of the
fan shroud from the vehicle. Take care
not to damage the face of the radiator
when removing the shroud.
12.
Remove the two upper condenser
mounting bolts that attach to the
radiator cross brace.
13.
Mark the location of the hood
latch, then remove the hood latch
from the latch support. The latch is
held in place by three bolts. The latch
support is shown in Figure 6. It is not
necessary to remove the cable from
the latch, just place the latch and cable
assembly out of the way.
14.
Remove the two bolts that attach
the latch support to the radiator cross
brace and the 4 lower attachment bolts
(2 per side). The two bolts that attach
the upper support to the radiator cross
brace are accessed from the engine
compartment side of the vehicle.
15.
07-10 LMM: Only Remove the (2)
top oil cooler bracket to free the oil
cooler from the latch support bracket.
See Figure 8.
16.
Swing the latch support forward
as shown in Figure 9.
17.
Pull the air conditioning condenser
out of it’s lower mounts, and place it
against the latch support.
18.
Remove the two upper Charge
Air Cooler (CAC) mounting bolts and
unfasten the fender support rod from
the cross brace as shown in Figure 10.
19.
Remove the 6 bolts (3 per side)
that secure the radiator cross brace.
The cross brace is shown in Figure
10. The bolts are on the bottom side at
each end of the support. Remove the
cross brace from the vehicle.
20.
Remove the air box-mounting tray
from the vehicle shown in Figure 11.
Figure 8 07-09 LMM: Shown