Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Tuner- Six-Gun Diesel Tuner & SpeedBrake, For use with Banks iQ '03-07 Compatible with PowerPDA - Manual (Page 21)

96825 v.6.0
21
Figure 20 Remove column panel covers
15.
Now, connect the 8-pin connector
from the Banks SpeedBrake Wire
Harness to the 8-pin connector on the
Six-Gun/EconoMind In-Cab Cable.
16.
Locate the Foot Brake position
switch connector under the dash. See
Figure 19. Disconnect the foot brake
position switch connector.
17.
Locate the Brake Position Switch
intercept connectors on the Banks
SpeedBrake Wire Harness. connect
the female connector on the Brake
Position Switch intercept connectors
to the factory black brake position
switch connector. connect the male
connector on the Brake Position Switch
intercept connectors to the factory
female brake position connector that
was disconnected.
18.
From under the steering column,
remove the three (3) screws that hold
the steering column panel covers in
place. See Figure 20.
19.
Using a standard screw driver
remove the plastic ignition key guide.
See Figure 21.
20.
Move the steering column down
to the lowest possible position to aid
in removal of the top steering column
panel. Remove the top steering column
panel.
CAUTION: Be careful when
removing the top steering column
panel or damage may result.
21.
Locate the tow haul connector
under the main wire harness towards
the top rear of the steering column.
See Figure 22.
22.
Disconnect the tow haul
connector.
23.
Locate the tow haul intercept
connector on the Banks SpeedBrake
Wire harness. Route the Tow Haul
intercept connectors under the dash
towards the front of the vehicle and
up to the top of the steering column
following the factory harness to the
factory tow haul connector. Make sure
the connectors and wires are free of
rotation from the steering column.
connect the female connector on
the Tow Haul intercept connectors to
the factory male tow haul connector.
connect the male connector on the
Tow Haul intercept connectors to the
factory female tow haul connector.
Secure the connectors and wires with
supplied cable ties.