Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Tuner- Six-Gun Diesel Tuner & SpeedBrake, For use with Banks iQ '03-07 Compatible with PowerPDA - Manual (Page 36)

36
96825 v.6.0
Code Event Course of Action
1, 1
Insufficient
power supply
to SpeedBrake
module
Turn Ignition OFF and check connection at fuse tap, 10-pin
connection to module and 8-pin connection to Tuner. Turn
ignition back ON and re-check for presence of code.
1, 2
Brake signal
malfunction while
Brake is on
Turn Ignition OFF and check connections at 5-pin male and
female brake pedal connector. Turn ignition back ON and
re-check for presence of code.
1, 3
Insufficient voltage
to tow-haul switch
Turn Ignition OFF and check connections at 3-pin male and
female tow-haul switch. Turn ignition back ON and re-check for
presence of code.
1, 4
Brake Signal
malfunction while
brake is off.
Turn Ignition OFF and check connections at 5-pin male and
female brake pedal connector. Turn ignition back ON and
re-check for presence of code.
2, 1
No response to
generated OBD ISO
messages
Turn Ignition OFF and check connections at OBD II connection.
Turn ignition back ON and re-check for presence of code.
2, 2
Brake pressure
switch signal
malfunction
Turn Ignition OFF and check connections at 2-pin male and
female brake pressure sensor intercept connector and 2-pin
in-cab cable connector. Turn ignition back ON and re-check for
presence of code.
3, 1
Rear wheel slip
during braking
Module has detected rear wheel slipping. code will automatically
clear 30 seconds after traction regained.
3, 2
Power Up Error or
Internal Module
Malfunction
Turn Ignition OFF and check connection at fuse tap, 10-pin
connection to module and 8-pin connection to Tuner. Turn
ignition back ON and re-check for presence of code.
3, 3
Internal Module
Malfunction
Turn Ignition OFF and check connection at fuse tap, 10-pin
connection to module and 8-pin connection to Tuner. Turn ignition
back ON and re-check for presence of code.
4, 3
Exhaust Back
Pressure (EBP)
Input Voltage Out of
Range
Turn Ignition OFF and check the 46-pin male and female PcM
connectors. Turn ignition back ON and re-check for presence of
code.
4, 4
communication
failure to brake
module.
Turn Ignition OFF and check connections at 10-pin brake module,
8-pin Tuner, and OBD II connector. Turn ignition back ON and
re-check for presence of code.
5, 1
Internal Module
Malfunction
Turn Ignition OFF and check connections at 10-pin brake module,
8-pin Tuner, and OBD II connector. Turn ignition back ON and
re-check for presence of code.
If code does not re-appear at key ON, start engine and check for presence of code both at
engine idle and under varying driving conditions.
table 2: Banks SpeedBrake Fault Codes