Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Tuner- Six-Gun Diesel Tuner & SpeedBrake, For use with Banks iQ '03-07 Compatible with PowerPDA - Manual (Page 23)

96825 v.6.0
23
Figure 23 SpeedBrake Module Mounting Location
24.
connect the Banks SpeedBrake
module 10-pin connector on the
Banks SpeedBrake wire harness to the
SpeedBrake module. The connector
will be the only one with a label.
NotE: Make sure the correct
connection is made to the tuner and
the Banks SpeedBrake module before
proceeding.
25.
Remove the adhesive backing
from the dual-lock fasteners on the
back of the SpeedBrake Module and
attach the module to the location
shown in Figure 23. Apply light
pressure to the SpeedBrake Module by
hand for 60-seconds to create a strong
bond between the steering column
surface and hook & loop interlocking
fasteners. Using the supplied cable
ties, secure the Banks SpeedBrake
module wire harness away from any
moving components.
NotE: Make sure all mounting surfaces
are entirely clean and free of dirt and
oil before mounting the SpeedBrake
module. Clean and dry as required
using a cloth damped in rubbing
alcohol or similar cleaning solution.
26.
Install the top steering column
panel back in place.
27.
Reinstall the plastic key guide into
place. Make sure it is snapped into
place.
28.
Reinstall the three (3) factory
screws to fasten the steering column
plans back together.
29
. The RJ12 connector (phone like
connector) on the Banks SpeedBrake
Wire harness will be connected in
Section 3, step 7 or 10. Leave this
wire loose.
30.
Go over all connection. Secure
the wire harness with the supplied ties
under the dash.
WARNING: Take care to keep any
cables away from the pedals
or where they could become
tangled.
-END, SECTION 2-